How to attach jumper cables with Battery Pack

Our dedicated battery experts choose every product we feature. We may earn money from the links on this page.

How to Attach Jumper Cables with Battery Pack Jumper

Expert Reviewed Article by our Certified Editor, Christopher Bouchard, C.E.M.

Read the Manual: Before starting, read the battery pack’s manual for specific instructions and safety information.

Turn Off the Car: Ensure the car’s ignition is turned off. This prevents any electrical surges that might occur during the connection process.

Locate the Battery: Open the car hood and locate the battery. Identify the positive (+) and negative (-) terminals.

Prepare the Battery Pack: Make sure the battery pack is fully charged. Most packs have an indicator light to show their charge level.

Looking for a Car Battery Jumper Starter?

We get paid when you use our affiliate links, consider Using Our AMAZON© AFFILATE LINKS:

Attach the Red Cable (Positive) First:

Connect the red (positive) clamp to the positive terminal of the car battery.
Ensure the clamp is securely attached and makes good contact with the terminal.
Attach the Black Cable (Negative):

Connect the black (negative) clamp to a clean, unpainted metal surface on the car’s engine block or chassis. This acts as a ground and reduces the risk of sparks near the battery.
Some battery packs allow you to attach the negative clamp directly to the battery’s negative terminal. Check your pack’s manual for the preferred method.

 

Turn on the Battery Pack

 Switch on the battery pack according to the manufacturer’s instructions. Some packs have an on/off switch, while others activate automatically when connected.

Start the Car:

Attempt to start the car. If it doesn’t start immediately, wait a few moments and try again.
Do not crank the engine for more than 5-10 seconds at a time. If the car doesn’t start after a few attempts, wait a couple of minutes before trying again.

Disconnect the Cables

Once the car starts, carefully remove the clamps in reverse order: first the black (negative) clamp, then the red (positive) clamp.
Be cautious to avoid the clamps touching each other or any metal surfaces.
Recharge the Battery Pack: After use, recharge your battery pack as soon as possible so it’s ready for future use.

Amazon and the Amazon logo are trademarks of Amazon.com, Inc. or its affiliates
We hope you found this information helpful

Consider reading additional articles on our site

If You found this information useful, Leave us a comment!

We may earn a commission for purchases made through our links. Amazon and the Amazon logo are trademarks of Amazon.com, Inc. or its affiliates.

More Articles & Posts

Verified by MonsterInsights